A przeprowadziłeś procedurę uruchamiania czujnika opisaną w instrukcji?
Czujnik ma losowo przypisany kod bezpieczeństwa, który w określonym czasie musi odebrać stacja.
SETTING UP
1. First, insert the batteries to the transmitter (see “How to install and replace batteries
in the Temperature transmitter” below).
2. Within 2 minutes of powering up the transmitter, insert the batteries to the Weather
station (see “How to install and replace batteries in the Weather station” below).
Once the batteries are in place, all segments of the LCD will light up briefly. Then the
indoor temperature and humidity, the time as 0:00 the date as SA.1., the weather icons
(sun and clouds) will be displayed. If the indoor temperature and humidity are not
displayed after 15 seconds, remove the batteries and wait for at least 1 minute before
reinserting them. Once the indoor data is displayed proceed to next step.
3. After the batteries are inserted, the Weather station will start receiving data signal from
the transmitter. The outdoor temperature and humidity should then be displayed on the
weather station. If this does not happen after 2 minutes, the batteries will need to be
removed from both units and reset from step 1.
4. In order to ensure sufficient 868 MHz transmission however, this should under good
conditions be a distance no more than 100 meters between the final position of the
Weather station and the transmitter (see notes on “Positioning” and “868 MHz
Reception”).
